![]() * Full disclosure: I love this tool so much and use it every week, so I am an approved Affiliate of Topaz Labs. If you have any others, please let me know! That’s kind of the run down on my list of tips for this tool, I think this should answer all of the questions I’ve seen about it (I hope!). You can also adjust your brush settings to suit the area being targeted. ![]() You can invert the masks and switch on and off the overlay. Use the Sub (black) and Add (white) brushes to regain detail where needed in a targeted way. That means that DeNoise is effecting the whole image evenly. Using the mask button will give you a white mask. Sometimes you want the details back in places and with some subjects, you lose all coat detail completely (*achem* Horses…) so in these situations, it’s time to mask. Keep sharpening set low, under 10 is usually more than enough! You can always do a high pass sharpen later. Then, increase slowly in little sections until your noise is removed appropriately. My advice would be to turn both sliders right down – like 2 or 3 or 4. The “Auto” settings always overcook the situation for me! Way too much sharpening, the introduction of artefacts and other weird things tend to happen when Auto is running the show. I’ve never used AI Clear, but regularly switch between DeNoise and Low Light depending on the coat of the dog and the level of noise in shot. Low Light: For use in higher noise situations or with fluffy coats (like Alfies around his head).AI Clear: Theoretically best for colour noise but I’ve never used this on a final image.DeNoise: The “normal” solution that should work for most cases, Auto will be too strong (see next section).In my understanding, the use-cases of these are as follows: ![]() Within the current version of DeNoise AI that I have, there are three “mode” options. With that done, it’s time to explore the actual system itself… 2.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |